Mine Dump Truck 3304
Mine Dump Truck 3304
Mine Dump Truck 3304 Technical Data

Frame
Full box section frame rails with integral front bumper and closed-loop crossmember. Torque Tube and Crossmember and mounting castings of high yield strength steel.

Engine
Model:Cummins M11-C300
Type: 4 Cycle,Turbocharged/Aftercooled
Gross Power@2100rpm:224KW
Net Power@2100rpm:214KW
Gross Power rated to SAE J1995 Jun 90.
Turbocharged engine requires no deration up to 3048 m altitude.
Maximum Torque:1376Nm@1300rev/min
Cylinders/Configuration: 6 in line
Bore X Stroke:125 X 147mm
Displacement: 10.8L
24 volt negative ground electrical system; two 12v, 165Ah batteries with master disconnected swich; 7.7kw electric starer,50A

Clutch

Single disc dry clutch,hydraulic-air assist operation.

Transmission

MRT-11710B Twin Counterchaft main gearbox with rear mounted auliliary planetary gearbox, all the gears is axle bush engage shift and air pressure for the auxiliary gearbox.Ten forward and two reverse.
Ratios and speeds(km/h)

Forward
Reverse
1st
2nd
3rd
4th
5th
6th
7th
8th
9th
10th
Hight
Low
Ratioos
14.73
11.00
8.17
6.00
4.46
3.30
2.46
1.83
1.34
1.00
3.38
15.10
Speed(km/h)
3.40
4.56
6.14
8.35
11.23
15.19
20.34
27.39
37.26
50.12
14.82
3.32

Drive Axle

NHL heavy duty axle with full floating axle shafts, single reduction sprial bevel gear differential, and planetary reduction at each wheel.

Standard
Optional
Ratios
Differential
2.50:1
3.13:1
Pianetary
4.59:1
4.59:1
Total Reduction
11.48:1
14.37:1

Suspension

Front :NHL manufactured king pin strut type independent front wheel suspension by self-contained ,variable rate, nitrogen/oil cylinder. Rear :NHL manufactured variable rate nitrogen/oil cylinder with A-frame linkage and lateral stabilizer bar.
Maximum Strut Stroke:Front: 225mm
                                  Rear: 160mm
                                  Maximum Rear Oscillation:±8°

Tyres

Standard:front & rear 18.00-25(28PR) E3 Tubeless Rim:13.00/25
Note:Under certain job condition the t-km/h(ton-mile/h)capacity of standard or optional tyres may be exceeded .We recommend that tyre manufacturers be consulted for optimum type selection.

Brakes

SERVICE:dual shoe,internal expanding,mechanically actuated by air pressure.Independednt front and rear circle systems actuated by single treadle valve with auxiliary manual control.Operator controlled dry/wet road valve reduces front brake pressure 50% for improved control in slippery conditions
           Front Linings:Diameter x width:508x 152 mm
                               Area-front axle: 3459 cm2
          Rear Linings: Diameter x width::508x 190 mm
                              Area-rear axle: 4323 cm2
          Total Lining Area: 7782 cm2
Emergency-Warning light in cab indicates when air pressure drops below 550Kpa.Front and rear brakes automatically actuates if system air pressure falls to 310Kpa.
PARKING-Service brakes act as parking brakes when applied by manual control valve on instrument panel

Steering

Full hydraulic power steering by two double-acting when applied cylinders. Pressure is supplied to a load sensing and priority steering valves by an engine driven gear pump. The system provides uniform steering regardless of engine speed.
Maximum Tire Steering Angle:40 Degrees

Hoist

Two body hoists mounted inside the frame rails.Hoist are two –stage with power down in the second stage.Hydraulic system is powered by the gear pump.
Body Raise Time:13 seconds
Body Lower Time:9 seconds

Body

Longitudinal “V” shape floor plate with integral transverse box –section stiffeners the body resilient inpact absorption pads.
Body wear surfaces are high strength and high hardness abrasion resistant steel.

Plate Thickness :
          Floor: 12mm
          Side: 8mm
          Front: 8mm
Volume:
          Struck(SAE): 14.3m3
          Heaped2:1 (SAE): 18m3

Optional Equipment

Automatic Lubrication system                    Cold Protection Curtain
Engine Cold Start Kit                                 Body Heating,Exhaust
Fire Extinguisher                                       Tyres, 18.00R25** Radial
Coal Body

Weights

kg
Net Weight
20000
Rated Payload
28000
Gross Weight*
48000

*Gross weight includes options, Attachments, full fuel tank and rated payload.

WEIGHT DISTRIBUTION Front Axle Rear Axle

Weight distribution
Front Axle
Rear Axle
Empty
53.3%
46.7%
Loaded
36%
64%

Service Capacities

SERVICE CAPACITIES
L
Engine Crankcase and Filters
34.0
Transmission and Filters
13
Colling System
76
Fuel Tank
330
Hydraulic Oil Tank
129
Steering & Body Hydraulic System(Total)
146
Planetaries(Total)
30
Differential
57.0
Front Ride Strut(Each)
14.0
Rear Ride Strut(Each)
8.0
Mine Dump Truck 3304 Performance Data
Unit equipped with 18.00-25tyres
Graphs based 0% Rolling Resistance
Mine Dump Truck 3304
Note: All specifications on our web-site are subject to technical modifications without notice.
Download information files

Top Back

无标题文档